Technical data

”””    Page 44
6.3.2 Connecting to AC Power Source via the AC/DC Adapter
The Operator Interface Computer 10"/15"/17” NEMA4 system, IP10IA99 / IP15IA99 / IP17IA99, can be optionally
connected to an AC power source via the optional AC/DC adapter (refer to Fig.5-27).
Fig.6-16 Connecting to AC power source via the AC/DC adapter
1. Connect the 5-pin DC connector of the AC/DC adapter (refer to Fig.5-27) to the appropriate DC power
connector (refer to pos. 12, Fig.5-15) of the Operator Interface Computer 10"/15"/17” NEMA4 system,
IP10IA99 / IP15IA99 / IP17IA99. The DC power connector of the system is on the rear bottom side and is
labeled “12~24V DC”. Make sure the connector is securely locked in place.
2. Connect the AC power cord to the AC/DC adapter.
3. Plug the AC connector of the adapter into an AC wall outlet of the AC power source.
4. Turn on the Operator Interface Computer 10"/15"/17” NEMA4 system, IP10IA99 / IP15IA99 / IP17IA99, via
the power button (refer to “Power Button and Power LED”).
Please observe the recommendations given in the section of "Safety Instructions”. Attach the supplied
AC power cable (for EU or US) that corresponds to the requirements of the country where the system is
used.