Technical data

”””    Page 37
6.1.6 DC Power Input Installation
6.1.6.1 AC/DC Power adaptor installation
1. Female type 5-pin terminal block connector.
2. Insert and fix the connector according to power
definition (left 3-pin)
Fig.6-5 : Power adaptor installation
6.2 Panel and External AC/DC Adapter Mounting
6.2.1 Panel Mounting
All Operator Interface Computer 10"/15"/17” NEMA4 system, IP10IA99 / IP15IA99 / IP17IA99, configurations
come in the delivering status with mounted mounting clamps (Fig.6-10, depending on the ordered system). These
mounting clamps have to be removed at first in order to install the system into a sub-frame or a panel. Loosen the
screws enough to allow the removing of the mounting clamps from the enclosure (but do not entirely remove the
screws from clamps).
First of all, check the wall thickness and the cut-out dimension, then insert the mounting kit step by step as the
following illustration.
Fig.6-6: Cut-out definition