Technical data

”””    Page 35
6.1.4 Serial ATA Hard Disk Installation Method
Unlike IDE bus, each Serial ATA (SATA) channel can only connect to one SATA hard disk at a time; there are total two
connectors, J6 and J18. The installation of Serial ATA is simpler and easier than IDE, because SATA hard disk doesn’t
require setting up Master and Slave, which can reduce mistake of hardware installation. The step 1 to 6 is HDD
installation, and step 6 to 1 is HDD un-installation.
1. The removable HDD tray on the upper left side.
2. Fix the anti-vibration washers on HDD tray first
3. Fix the HDD to the removable tray with screws
4. Connect the HDD SATA cable & power cable and apply
sticker cloth as illustrated.
5. Put the fixed HDD tray back to the cover
6. Screw the HDD tray and finish.
Unscrewing the removable HDD tray shouldn’t be operated unless the unit is turned off and the tray is not hot.
Fig.6-3 : The procedure of HDD installation