Technical data

”””    Page 23
5.3.2.1 USB Connectors
The system is equipped at the bottom side (rear) with two USB 1.1/2.0 interface connectors and two
USB1.1/2.0 for additional Extension (#1 and #5, Fig.5-19). These connectors provide connections for
USB-compatible devices.
5.3.2.2 COM port Serial Interface Connector
This RS232/RS422/RS485 connection (marked as COM1, COM2) (#2 and #3, Fig.5-19) are available, and RS232
connection (marked as COM3, COM4) for extensional selection as 2*5 Pin Box Header/2mm Right Angle connectors
(female) and provides connection RS232 for serial devices.
5.3.2.3 LAN1 and LAN2 Ethernet Interface Connectors
These interface connectors (#6, Fig.5-19) are provided as RJ45 sockets with integrated LEDs.
Ethernet Port
Data Transfer Rate
LAN1
10/100/1000 Mbps
LAN2
10/100/1000 Mbps
Ethernet LED States: Left LED State
Link Activity State
Right LED State
Link Speed
Off No Active Off 10 Base-T
Yellow Active Green 100 Base-T
Orange 1000 Base-T
5.3.2.4 VGA Interface Connector
An external (analog) monitor can be plugged into this interface (#4, Fig. 5-19) which is provided as a 15-pin D-SUB
socket.
5.4 Top View
Fig.5-22: Rear side of the system (shown as 10.4” IP10IA99 )
1
HDD slot (SATA)
2
Cover the obstructs the access to the CF-slot
3
Panel Mounting Slots with installed mounting clamp and screw
4
Front panel with seal on the rear side
5
Screws that secure the cover on the top side