User's Manual

Photo A:
Power Switch 433MHz ID Channel Tack switch
(only AWV698C applicable)
Photo B.:
Channel Indicator: CH1 ~ CH7
Remote Control Indicator
Photo C.:
(Receiver)
Audio R Audio L Video Power Plug (9V)
(Transmitter)
plug for IR cable LED (transmitter)
Photo D.:
(Shown above is the antenna direction for application.)
Specification
Transmitter:
1. Frequency: 5.725GHz – 5.875GHz
2. Channel: 7 selectable channels
3. Modulation: FM-FM
Input level: Video - 1 Vp-p (PAL)
Audio - 3 Vp-p
Impedance: Video - 75 ohms (PAL)
Audio - 10K ohms
4. Input port: SCART line cable
5. Antenna: Built in antenna
6. Power supply: DC 9V power adapter
Receiver:
1. Frequency: 5.725GHz – 5.875GHz
2. Channel: 7 selectable channels
3. Output port: SCART line cable
4. Antenna: Built in antenna
5. Power supply: DC 9V power adapter
Trouble Shooting
If a problem occurs, first refer to this information before
you take the device for repair.
If you are unable to rectify the fault using the information
given here, contact your local dealer or service specialist.
Under no circumstances should you attempt
to repair the device yourself, as this would
invalidate the warranty.
PROBLEM POSSIBLE
CAUSE
REMEDY
The transmission
channels for the
transmitter/receiver
do not correspond.
Set the
transmission
channel on the
transmitter/receiver
The transmission
distance is too
great.
Reduce the
distance.
Connecting cable. Check the
EURO-AV plug
and the cinch plug.
No
picture/sound
transmission
Transmitter or
receiver not
switched on.
Switch on the
transmitter or
receiver
Wrong direction of
patch antenna
Adjust the antenna
to the right
position. See photo
D.
Move the
transmitter or
receiver a few
centimeters
Interference.
Change the
transmission
channel on the
transmitter/receiver
Microwave units
and the use of the
so-called ”blue
tooth function”
(W LAN) on mobile
phones or
notebooks.
Change channel to
find better channel
to receive.
Poor
picture/sound
quality
Infrared module. Check the
connection and
position of the
infrared module.
The remote
control of the
signal source
does not
respond.
A wireless
transmitter in the
433MHz range
(e.g. a
baby-phone) is
interfering with the
transmission.
Switch this device
off.
DOC0000-0269
Transmitter
Receiver