User's Manual

AW 96 Series System Installation Manual
___________________________________________________________________________
AirWalk Proprietary and Confidential Page 41 of 72 6/14/2006
8 AW 96 Low Power (PicoCell/MicroCell) Cabling
The following connections are required for AW 96 stand-alone applications, including
PicoCell and MicroCell. AW 96 units for these applications are normally configured for
50mW power output and are equipped with an internal duplexer function which requires
only a single antenna for normal operation. A second diversity receiver connection is
provided if required for the application
Connect power, Ethernet, GPS and RF antenna cables as shown in the diagram below.
Use only the AC power cables provided with AW 96 unit unit to ensure continued safe
operation.
Use recommended RF and Ethernet cables or equivalent.
Use the optional AirWalk GPS antenna kit (AWANC001GPCA01) when GPS is required
for the application. This kit includes a GPS antenna, mounting hardware and a 25m
cable.
Note the GPS antenna must located outside in a position to see the general sky. The
GPS antenna must see at least 4 GPS satellites in the sky to receive enough time
information for proper system operation when GPS is required.
GPSANT
RF RXB(a) RF RXA(a)
RF TX
(a)
RF RXB(b) RF RXA(b)
RF TX
(b)
RF RXB(r) RF RXA(r) RF TX (r)
T_EVEN
T_10MHz
RU IF BSC IF
ENV IF BTS IF
GPSANT
RF RXB(a) RF RXA(a)
RF TX
(a)
RF RXB(b) RF RXA(b)
RF TX
(b)
RF RXB(r) RF RXA(r) RF TX (r)
T_EVEN
T_10MHz
RU IF BSC IF
ENV IF BTS IF
10/100 Ethernet Switch10/100 Ethernet Switch
Main
Tx/Rx
Antenna
Optional
Diversity
Antenna
RF Cables
Cables: 2, one Tx, one Rx
Connectors: SMA M – N Type M
Cable Type: RG-400 or equiv
RF TX (α)
SMA F
Connector
GPS Cable
Connectors: TNC M-TNC M
Cable Type: RG-58 or equiv
Outdoor GPS
Antenna
GPS ANT
TNC F
Connector
Ethernet Cables
Cables: 2, one BSC I/F, one BTS I/F
Connectors: RJ-45
RF RXA (α)
SMA F
Connector
BSC IF
RJ-45
BTS IF
RJ-45
To WCA/MG & BSM (Ethernet)
Supplied AC
Power Cord
Standard
IEC Connector