Specifications

Page 77
hELi MODEL TyPE
GYRO 1 and GYRO 2 setting range is -150% to 150%. The default settings are 100%. Decreasing the GYRO percentage
values decreases gyro gain and increasing the GYRO percentage values increases gyro gain. See the IMPORTANT note on
the previous page regarding the use of positive and negative Gyro percentage values and how they may change your gyro
operating mode.
When the either the Gyro 1 or Gyro 2 percentage values are set to 0%, the gyro will be in 'pass-through' mode (e.g., OFF)
for that selected Gyro function only.
Changing the Gyro Percentage Values, Continued....
20. & 21.c-MiX1 anD c-MiX2 (cOMPEnSaTiOn MiXing)
The Compensation Mixing function is used to create your own custom mix if one of the pre-programmed mixes is not suitable. For
example, you can create a custom mix that mixes elevator to throttle or that mixes rudder to throttle. Elevator to throttle mixing is
typically used during 3D ying to provide a momentary burst of throttle under hard cyclic load. Rudder to throttle mixing is typically
used to reduce the tendency of the helicopter to slightly rise and fall as you pirouette.
Because any of the six channels can be programmed as a Master or a Slave, you are able to program custom mixes for just
about any situation required. Compensation Mixes are composed of a Master channel and a Slave channel. Any of the available
six channels can be programmed as a Master or a Slave. The same channel can even be programmed as both a Master and a
Slave. In addition to programming the High and Low Rate percentage values, the Slave channel Offset percentage value can be
changed to move the neutral point of the Slave channel servo when the Compensation Mixing function is Activated.
For greater exibility, both Compensation Mixing functions can be programmed either the same for all Flight Modes or separately
for each of the three Flight Modes.
Transmitter F-MODE refers to the Flight Mode that the transmitter is currently operating in. Programming F-MODE refers
to the Flight Mode that you would like to change the programming for.
Programming F-MODE
Transmitter F-MODE
In all cases, the Master channel always controls the Slave channel.
Choosing the Flight Mode - Common or Separate
1) From the Display screen, press the ENTER key to display the Programming
Menus.
2) Press the Navigation Pad
56
to highlight either C-MIX1 or C-MIX2,
then press the ENTER key to display the C-MIX1 or C-MIX2 menu. The
cursor will default to MASTER>EL.
3) Press the Navigation Pad
5
to move the cursor to F-MODE>COMMON.
4) Press the INC+/M1 or DEC-/M2 keys to choose either SEPARATE or
COMMON.
5) If you choose SEPARATE, press the F-MODE key to choose the F-MODE
number you would like to program the Compensation Mixing function
for. Choose from FN, F1 or F2.
HELI MODEL TYPE