User's Guide

AT S58-4020 5.8GHz Motion sensor
Version 1.1 9
10.8 Information on test modes and additional testing requirements:
When testing host product, the host manufacture should follow FCC KDB Publication 996369
D04 Module Integration Guide for testing the host products. The host manufacturer may operate
their product during the measurements. In setting up the configurations, if the pairing and call box
options for testing does not work, then the host product manufacturer should coordinate with the
module manufacturer for access to test mode software.
10.9 Additional testing, Part 15 Subpart B disclaimer:
The modular transmitter is only FCC authorized for the specific rule parts (FCC Part 15.249) list
on the grant, and that the host product manufacturer is responsible for compliance to any other
FCC rules that apply to the host not covered by the modular transmitter grant of certification. The
final host product still requires Part 15 Subpart B compliance testing with the modular transmitter
installed when contains digital circuity.
10.10 Information on test modes and additional testing requirements:
When testing host product, the host manufacture should follow FCC KDB Publication 996369
D04 Module Integration Guide for testing the host products.
The host product shall work normally, all the transmitters installed must be operating, investigate
the fundamental and unwanted/spurious emissions with the modular transmitter(s) operating in a
normal mode. When testing for emissions from the unintentional radiator, the transmitter shall be
placed in the receive mode or idle mode if possible, if receive mode only is not possible, test
laboratories may need to add attenuation or filters depending on the signal strength of any active
beacons (if applicable) from the enabled radio(s).