User's Guide

AT S58-4020 5.8GHz Motion sensor
Version 1.1 8
10.6 Antennas:
Type
Gain
Impedance
Application
PCB type
FA Antenna
2.3dBi
50Ω
Fixed, Mobile, Portable
The antenna is permanently attached, can’t be replaced.
10.7 Label and compliance information
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed andused in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
The system integrator must place an exterior label on the outside of the final product housing the
ATS58-4020 Modules. Below is the content that must be included on this label.
The host product Labeling Requirements:
NOTICE: The host product must make sure that FCC labeling requirements are met. This
includes clearly visible exterior label on the outside of the final product housing that displays the
contents shown in below:
Contains FCC ID: 2AVK2-ATS58-4020