User's Guide

AT S58-4020 5.8GHz Motion sensor
Version 1.1 7
10. Requirement of FCC KDB 996369 D03 for module certification:
10.1 List of applicable FCC rules:
The module complies with FCC Part 15.249
10.2 Summarize the specific operational use conditions:
The module has been certified for Fix, Mobile, Portable applications. This transmitter must not
be co-located or operating in conjunction with any other antenna or transmitter.
10.3 Limited module procedures:
The module has not its own RF shielding, which belong to Limited module
Standard requires:
Clear and specific instructions describing the conditions, limitations and procedures for third-
parties to use and/or integrate the module into a host device (see Comprehensive integration
instructions below).
Resolve: Supply example as follows:
Installation Notes:
1) ATS58-4020, ATS58-3220, ATS58-3020 module Power supply range is DC 4.5~5.5V, when
you use ATS58-4020, ATS58-3220, ATS58-3020 modules design product, the power supply
cannot exceed this range.
2) When connect ATS58-4020, ATS58-3220, ATS58-3020 module to the host device, the host
device must be power off.
3) Make sure the module pins correctly installed.
4) Make sure that the module does not allow users to replace or demolition
5) The module is typical installed and assembled into a lamp and turns the lamp to be a radar
induction lamp. After assembled, the transmitter part of the module faces to the screw side which
is made of the material of aluminum of the lamp. The screw side becomes a big shielding part to
cover the module.
10.4 Trace antenna designs:
Not applicable.
10.5 RF exposure considerations:
This equipment complies with FCC’s RF radiation exposure limits set forth for an
uncontrolled environment. The antenna(s) used for this transmitter must not
be collocated or operating in conjunction with any other antenna or transmitter.