User's Guide

ATS58-1818 5.8GHz Motion sensor

Version 1.1

This equipment complies with FCC’s RF radiation exposure limits set forth for an uncontrolled

environment. The antenna(s) used for this transmitter must not be collocated or operating in

conjunction with any other antenna or transmitter.

Note: the host product manuals must include a statement in order to alert the users of FCC RF

exposure compliance.

11.6 Antennas:

Type Gain Impedance Application

PCB type 2.3dBi 50Ω Fixed, Mobile, Portable

The antenna is permanently attached, can’t be replaced.

11.7 Label and compliance information

This device complies with part 15 of the FCC rules. Operation is subject to the following two

conditions:

(1) this device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates uses

and can radiate radio frequency energy and, if not installed andused in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause