User's Guide

AT58L4M32-2020 Motion sensor
Version 1.2
Page 4
Input and Output Interface
Five pinholes are reserved in the module. There are five signal pins, VCC, GND,
out, TX and Rx. The pin distance is 2.54mm. If you need to adjust the distance and delay
time online, you can rewrite the internal parameters through the communication between
TX, RX of UART with AT58MP1T1RS32A. The following table is the definition of each pin
：
Pin Name
Function
Note
VIN
Power supply
VCC is 5V by default, external LDO is needed if VCC higher than 6V.
GND
Ground PIN
OUT
Output control
Output is 5V TTL by default, could be PWM if needed
TX
TX of UART
used for software upgrade or performance parameter adjustment. The
high level voltage is 3.3V
RX
RX of UART
used for software upgrade or performance parameter adjustment. The
high level voltage is 3.3V