Installation guide

C
-75 Installation Guide 21
5. C-75 Config Shell Commands
The following tables detail the C-75 config shell commands.
Table 5-1 get Commands
get Commands
Command
Description
get ap
Displays all the currently visible APs
get interface
Displays network interface speed and mode
get ip config
(deprecated)
Displays the IP information
get log
Displays the log information as it is created
get log config
Displays the configuration of the logger
get mode
Displays the mode in which the device is currently configured
get rf
Displays if RF monitoring for the device is ‘ON’ or ‘OFF’
get serial num
Displays the board number
get server
discovery
Displays the server discovery/setting information
get status
Displays the current running status of all the components
get version
Displays the version and build information of all the components
get vlan config
Displays VLAN configuration. Both static and dynamic information is displayed.
get vlan id
Displays listing of all VLANs which can be detected by ND.
get vlan status
Displays status of VLANs which are configured for monitoring by ND.
get vlan
connectivity
Pings the specified VLAN other than the communication VLAN.
get model
Displays the AP model.
get antenna
Displays antenna configuration (internal/ external).
get route
Displays IP routing table entries.
get client logs
Gets client connection logs as it happens.
get wired trace
Performs packet capture on Ethernet interface(eth0) upto file size 5MB.
get ap status
Displays wireless profiles and associated clients.
Table 5-2. set Commands
set Commands