Installation guide

C
-75 Installation Guide 19
Figure 4-1 The set server discovery Command
Note: If IP address/ host name based discovery is being used and more than one server is present on the
network, then you must enter the IP address of the appropriate server.
Configure Network Settings
Configure a static IP address in absence of a DHCP server
1. Connect a crossover cable from the computer to the Ethernet port of C-75.
2. Configure the LAN IP address on the computer in the subnet 192.168.1.0/24.
3. SSH to IP address: 192.168.1.245 (factory default)
4. Log in to the CLI of the device using default credentials.
5. Configure server discovery on the device.
6. Configure a static IP address on the device. For example: Untagged VLAN 192.168.2.x/24.
After completing this step you will lose the SSH connection.
7. Configure the LAN IP address in the range of 192.168.2.x/24 and again SSH to the address assigned
in step 6.
8. Check the configuration settings.
9. Remove the crossover connection to the computer and connect the Ethernet port to the local switch.
Configure IPv6 settings
C-75 is IPv6 capable. Use the set ipv6 config command to configure advanced options such as DHCP
settings, auto negotiation, and manual configuration.
• Enable auto negotiation to discover IP address automatically.
• Enable DHCP settings to obtain addressing as well as more information, such as the DNS address from
DHCP server in the network.
• Enable manual configuration to provide manual IPv6 address as well as IPv6 default gateway.
How to configure Communication Key or Passphrase