Installation guide

C
-75 Installation Guide 16
Figure 3-4. Power Up C-75
To connect C-75 to the network, perform the following steps:
1. Ensure that a DHCP server is available on the network to provide network configuration to the C-75.
2. Connect one end of the network interface cable to the Ethernet port at the rear of the C-75.
3. Connect the other end of the network interface cable to an Ethernet jack on the desired subnet.
Wait until the device is ready (approx. 10 mins).
Figure 3-5. Connect C-75 to network
4. Check the status LEDs on the device. If all LEDs glow green, then the device is operational and
connected to the server.