Installation guide

C
-75 Installation Guide 15
2. Add the DNS entry wifi-security-server on all DNS servers. This entry should point to the IP address of
the server.
3. Ensure that DHCP is running on the subnet to which the device will be connected.
Important: If DHCP is not enabled on a subnet, the device cannot connect to that subnet with zero-configuration.
If the DNS entry is not present on the DNS servers or you do not have the DHCP server running on the subnet,
you must manually configure the device. Refer to
Manually Configuring C-75 for further details.
Using C-75 with PoE
To power on and connect C-75 to the network using PoE, do the following:
1. Connect one end of the network interface cable to the Ethernet port at the rear of the C-75.
2. Connect the other end of the network interface cable to the Ethernet jack that provides PoE power.
Figure 3-3. Power Up and Connect C-75 using PoE
Using C-75 with power adapter
To power up the device, perform the following steps:
1. Plug the power cable into the DC power receptacle at the rear of the device.
2. Plug the other end of the power cable into an 110V~240V 50/60 Hz AC power source.
Wait until the device is ready. Refer to the respective LED details table based on the configured device
mode.