Installation guide

C
-75 Installation Guide 12
3. Installing the C-75
Clients can connect to your corporate network in wireless mode through the C-75 AP(s).
The C-75 must be plugged into your corporate network to perform the above-mentioned operation.
Important: To prevent disconnection or tampering by unauthorized personnel, it is extremely important to install
the device such that it is difficult to unplug the device from the network or from the power outlet.
Connecting C-75
This involves mounting the C-75, powering on the device, and connecting it to the wired network.
Mount C-75
Take a configured C-75, that is, ensure that a static IP is assigned to the device or the settings have been
changed for DHCP. Note the MAC address and the IP address of the device in a safe place before it is installed in
a hard-to-reach location. The MAC address of the device is printed on a label at the bottom of the product.
Recommended: You should label the devices using MAC addresses or at least your own convention. For
example, use serial numbers, so that you can easily identify the devices.