Installation guide

C-75 Installation Guide 10
The rear panel of the C-75 has an Ethernet port labeled LAN1, that enables you to connect the device a wired
LAN through a switch or a hub and provides the power for the device by using the 802.3af standard.
Figure 2-2 Rear Panel of C-75
Table 2-2 Rear Panel Port Settings for C-75
Port Description Connector Type Speed/Protocol
DC IN
Enables you to connect to and power on device
using 12 V DC power with 2.5 ampere.
--
--
Console
port
(Console)
Enables you to access the AP through a dumb
terminal interface irrespective of the AP state.
RJ45 or DB9
Baud rate to be set to
115200
Ethernet
(LAN1)
Enables you to connect the device to a wired
LAN through a switch or a hub. The device can
then communicate with the server.
This port also provides the power for the device
using the 802.3af standard
RJ45
10/100/1000 Mbps Ethernet
Power over Ethernet
LAN2
Can be used for advanced AP features.
RJ45
10/100/1000 Mbps Ethernet