User manual

In the "Repeater Settings" page, you will find a list of available access

points and repeaters the AP-301 can connect to.

Check the box to the left of the access point / repeater you would like

the AP-301 to connect to. The access point will appear in the list below,

titled "Access Points to Connect to". Click "Save" to complete the Repeater

Settings.

Important: The repeaters and the access point must all be operating on

the same channel for them to form a Mesh Network. They should also

have a transmit power of at least -70dBm. (In the above example, -

49dBm satisfies this requirement).

You need to configure the access point that will form a Mesh Network

with the AP-301 the same way as the AP-301. For example, to setup a

Mesh Network between a RT-211 and an AP-301, the Mesh settings

should be done the same way on both devices. The screenshot below

shows the RT-211 Mesh setup screen.

In this window, after you check the "Activate Bridge/Repeater

Connections" box, check the box to the left of the AP-301 that you have

already configured and click "Save".

The RT-211 and the AP-301 will now recognize each other. At the point

where the wireless signal from the RT-201 weakens, the AP-301 will boost

the signal and extend the coverage area.

Note: You can only use WEP encryption in a wireless network with a

MESH structure. You can find more information about this in the Wireless

Security section.

AirTies AP-301 User Manual