User manual

Rules can be created to classify data. To create, edit or delete rules
to to Traffic Classification under QoS option on the menu. To create
a new rule add some of the following information in the fields.
Rule Name Source: Enter a rule name for the rule
IP Address: Enter the source address that the data will come from.
IP Address Range: Enter a range of addresses that the data will
come from.
Port: Enter the source port that the data will come from.
Port Range: Enter a range of ports that the data will come from.
MAC Address Destination: Enter the source MAC address that the
data will come from.
IP Address: Enter the destination address that the data will be sent
to.
IP Address Range: Enter a range of addresses that the data will be
sent to.
Port: Enter the destination port that the data will be sent to.
Port Range: Enter a range of ports that the data will be sent to.
MAC Address: Enter the destination MAC address that the data will
be sent to.
Protocol: Enter the protocol of the data
DSCP/TOS: Enter the QoS values that the data will have.
Click Save to create a new rule. The rule will appear in the table.
Traffic Shaping
In the traffic shaping page you can limit the bandwidth of each
Class of Service. Go to the Traffic Shaping menu under the QoS
menu.
There are already four Class of Services defined. The bandwidth for
each Class of Service is limited so that CoS4 is guaranteed the
highest amount of bandwidth. The minimum and maximum amount
of bandwidth of each CoS can be changed. Please note that
changing these is only recommended for advanced users. Additional
Class of Service can be created by clicking Add. The minimum and
maximum guaranteed bandwidth should be entered. Click Save to
save your settings.
Traffic Mapping