User manual

e. In the following example, the SSIDs are called Floor_1, Floor_2
and Floor_3. This type of naming system has been used to help
your understand the procedure. But in practice we recommend
you use the same name for all SSIDs. For example, if they are
all called AirTies, users can automatically connect to the device
with the best signal strength.
Step One (Configuring the Modem):
1. Enter the Wireless Settings section of the WIRELESS main menu
in the device's web interface. Change the SSID name to
Floor_1. Enter the channel that the mesh network will use in the
Channel field. We recommended you use 1, 6 or 11. While the
Mesh Network is set up manually, the AirTouch box must not be
checked. Save your settings by clicking Save.
Step Two (Configuring the Repeater on Floor_2):
1. Enter the Wireless Settings section of the WIRELESS main menu
in the device's web interface. Change the SSID name to
Floor_2. Enter the channel that the mesh network will use in the
Channel field. The AirTouch box must not be checked. Save
your settings by clicking Save.
Step Three (Configuring the Repeater in Floor_3):
1. Enter the Wireless Settings section of the WIRELESS main menu
in the device's web interface. Change the SSID name to Floor 3.
Enter the channel that the "mesh network" will use in the
Channel field. The AirTouch box must not be checked. Save
your settings by clicking Save.