User manual

To create a static rule select Static Routing option from the
ROUTING menu.
You need to enter a destination IP address and the route that will be
taken to get there: Desitnation: Enter the IP address of the
destinaton Netmark: Enter the netmask for the destination IP
address. Connection: Select the network interface where the data
will be sent. Gateway: Enter the IP address of the host that can
transfer the data for the destination IP address. Metric: Specifiy the
number of hops (how many gateways) the data needs to travel
through. Click Save to save the static route. The static route will be
displayed in the list. The static can be deleted by checking the
delete checbox.
If your device supported WAN to VLAN Mapping, follow next steps
below.
WAN to VLAN Mapping
It is possible to creating mappings to allow data from the different
WANs to be sent to differernt VLANs on your LAN. To create a new
WAN to VLAN mappig go to the WAN and VLAN Mappings menu
under ROUTING menu.
Click NEW MAPPING.
Mapping Name: Give the mapping a name. Mapping Type: Select
either Routed or Bridged. WAN: Select a WAN interface from the list.
LAN: Select one or more LAN interfaces. Click Save to save your
settings.
MANAGEMENT
From the MANAGEMENT menu you can configure how the device is
managed.
To change the password used to protect the Web UI. Select
Password Settings.