User's Manual

TROUBLESOOTING
LED
Indicators
Condition
LED Behavior
Timing Explanation Recommended Action(s)
Blinking
-
Solid
(No blinking)
Solid
(No blinking)
Solid
(No blinking)
Blinking
Blinking in sync
Blinking in sync
Blinking
50ms OFF 5000ms ON 4000ms OFF 4000ms ON 1000msec OFF 1000msec ON
Power OFF Device is not ready
WLAN is active and the node
has an active strong Mesh
connection on the Radio
WLAN is active and all MESH
links on the Radio are weak
Radio is inactive or Searching
for radar activity
WPS
is in progress
WPS is succesful
Unconfigured device
WLAN active, Device configured,
No MESH link on the Radio
There is configured MESH
connection on the radio,
however connection is inactive
(Can not connect)
WPS is not successful
LED Color
(OFF/Dark)
White
Green
Red
(OFF/Dark)
Green Green Green Green
Red Red
State
Identifier
A
C
D
E
F
G
H
J
I
K
L
This behavior is temporary and
lasts for about 5 seconds, after
whi
ch the LEDs go to one of
the following states:
1) MESH with strong signal
(state D), and
2)MESH with poor signal (state E)
Device has factory setting and
is not connected to the home
network in any way (e.g., the
device is not wired to the router-
gateway)
First AP (wired to router- gateway)
AP is part of MESH, but unable
to find any of its MESH partners.
This behavior is temporary and
lasts for about 5
seconds, after
which the LEDs go back to the
state the device was in before
the WPS
attempt
Power the device on if desired.
No other action required.
Solid
(No blinking)
Power ON White B
just powered on, then please
wait for at least 2 minutes for
No action required. If unit was
the unit to complete its boot
process.
No action required. Please wait. No action required.
Bring device closer to another
de
vice on the MESH network.
No action required. No action required. If LED is red (state E) then bring
device closer to another device
on the MESH network
.
If LED is green (state D), then no
action is required.
Configure device (refer to
Quick Installation Guide)
No action required. Make sure other device(s) that
are part of the MESH network
are powered on and close
enough to connect.
On failure, repeat WPS attempt
after
bringing device near
another device that is already
on the MESH network
(i.e., in state D).
Power
2.4 GHz
5 GHz