User’s Manual Land Mobile Radio (LMR) Model: ATP-400B
exceeded. APPROVAL 1. FCC Approval FCC ID: ONKATP-400B 1) Safety Training Information Your FM Handheld Transceiver generates RF electromagnetic energy during transmit mode. This radio is designed for and classified as “Controlled Exposure / Occupation Environment”, meaning it must be used only during the course of employment by individuals aware of the hazards, and the ways to minimize such hazards. This radio is NOT intended for use by the “General Population / Uncontrolled Environment.
RF Exposure Tests for SAR are conducted using standard operating positions specified by the FCC with the phone transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of the phone while operation can be well below the maximum value. This is because the phone is designed to operate at multiple power levels so as to use only the power required to reach the network.
CONTENTS General Features 1. GENERAL FEATURES.................................................4 UNPACKING.................................................................5 OPTIONAL ACCESSORIES.........................................5 GETTING READY.........................................................2 DESCRIPTION..............................................................3 OPERATION .................................................................4 CHARGER AND BATTERY................................
of the battery pack in the bottom hole of the unit. Push the battery pack toward the back of the transceiver until a click heard. Removal: Turn off the transceiver. Hold the battery with the two side latch lever of it sliding down. While holding the latch lever down, pull the battery pack against the rear side of the transceiver. Separate the battery pack from the transceiver. Unpacking Unpack and check that all items have been enclosed.
Green Orange Blinking On Blinking On Low battery Receiving, monitoring Different sub-tone when receiving Initializing, programming and cloning ⓔ External Earphone/MIC and Programming Jack Socket ⓕ Speaker ⓖ Tx Output H/L ⓗ Function ⓘ Squelch (SQ) ⓙChannel Select Button Select the desired channel with pressing Up and Down button, pressing and holding down more than 1 second makes the channel moving fast.
2. 3. 4. 5. 6. Rotate the Power on/off and Volume Control Switchⓑ clockwise to turn power on, then the LED lights orange and power–up tone is generated after about on second, indicating the transceiver has passed the self–diagnostic. When you turn on the transceiver, it comes same channel and function with your last using. Rotate this switchⓑ clockwise to increase the volume or counterclockwise to reduce the volume. Rotate it ⓑ counterclockwise fully to turn power off.
Voltage Duty time (5-5-90) 2. Charger Input power Operating temperature DC 7.5V Over 8 hrs (90~250VAC) 10-30 deg. C Connect the charger to an appropriate outlet (90~250 VAC). Turn the transceiver power off and place the radio into the front socket of the charger. The red light illuminates during charging and the green light comes on when the charge is complete. When you place two batteries in the charger at the same time, the front battery will charge first.
