Installation Guide

INSTRUCTIONS FOR INSTALLING CORNER / FINISHED END STONES
(please read carefully BEFORE you unwrap your trays!)
IMPORTANT
Carefully review the AirStone installation instructions
(included in this carton, on a separate sheet). This
will give you a general overview on how to install
AirStone.
Open your Corner/Finished End carton and remove a
pack. Observe the way it is laid out. In each shrink
wrapped pack there are two sets of stones:
- Piece #1 and #2 are both 2” wide and are mates
- Piece # 3 and #4 are both 4” wide and are mates
- Ends “A” are squared
- Ends “B” have one rolled end
Each piece must be used with its mate. This is
because the outer ends of these two stones (the
square end “A” and the rolled end “B”) are mirror
images of one another, so their face contours will
match to create our patent pending corner design.
By pairing together at a 90º angle the square end “A”
with the rolled end “B”, you create beautiful corners!
TO CREATE A FINISHED EDGE (for when a wall ends abruptly and the end of the stone is seen.
Create a natural, finished end with these components).
Use the rolled-end stone as the last stone of the row. Use its mate anywhere as primary stone.
INSTALLING CORNERS
1. Spread adhesive onto the back of a squared-end
piece (i.e., PIECE 1 or PIECE 3).
2. Press the piece to the wall so that end A is flush
with the end of the wall, as shown below.
3. Apply adhesive to the back of its rolled-end mate.
Note: Do not get adhesive on the extending portion
of End B (the portion of the stone that extends
beyond the wall). Press to the adjacent wall, as
shown above.
INSTALLATION TIPS
• Install your corner stones first. Make sure the edge of
all the stones are square to one another.
• For every vertical row, alternate between walls the
rolled edge stone so that the seams are staggered,
as shown below:
• The thickness of the adhesive used on the back of
the stone effects the stone’s length. Try to be
consistent.