User's Manual

uMAXe Installation Guide
Page 44 Commercial in Confidence UGD-D00218 Rev A
8 Initial WEB Configuration
Configure an uMAXe base station using the built in web based interface. This prepares the
equipment for connection to Netspan.
8.1 Initial configuration
To set initial configuration, perform the following:
Caution: The GPS antenna should be installed and attached before uMAXe is
powered on.
Caution: Wait two minutes before performing other actions.
1. Apply power to the uMAXe.
2. With the uMAXe powered-up connect the PC to the Ethernet port.
3. Configure the PC with an IP address in the 192.168.0.xxx range (e.g. 192.168.0.xxx
subnet 255.255.255.0).
4. In a browser, open web page with address 192.168.0.1 (uMAXe default IP address).
5. Enter the default username and password:
Username = macromaxe
Password = macromaxe
8.1.1 General Config
Figure 31 – General BS Configuration Initial
6. Enter the BS ID
Note: The format of the BS ID is important: NN-NN-NN-nn-nn-nn (where NN-
NN-NN is the Operator ID and nn-nn-nn is a unique address ID).
7. Select the BS Action from the available list.