User's Manual

uMAXe Installation Guide
Page 42 Commercial in Confidence UGD-D00218 Rev A
6 Connect and Manage Cables
The Ethernet cable is connected to the uMAXe using a standard RJ45 connector protected by a
harsh environment protective casing.
Figure 27 – Ethernet connector cable termination
6.1 Assemble Ethernet Connector
1. Pass the Cat 5 cable through the seal, front connector, body and tail nut of the
environmental connector casing as shown above.
2. Remove clear protector and paste the front seal on the collar of the connector body.
3. Terminate the Ethernet cable with an RJ45 connector plug.
4. Seat the RJ45 connector plug securely into the body cavity.
5. Tighten the tail nut on to the body forcing the seal to compress around the cable.
Figure 28 – Ethernet environmental connector assembly