User's Manual

uMAXe Installation Guide
Page 35 Commercial in Confidence UGD-D00218 Rev A
5.4.1 Install Dual Slant Antenna
Figure 17 - uMAXe Antenna Dual Slant Mast Mount Configuration
Note: Mounting kit (50 > 115 mm) is included.
To mount the dual slant antenna for the uMAXe in the mast mount configuration, perform
the following steps:
1. Attach the Antenna brackets to the top and bottom of the radome.
2. Attach the tilt arm to the top bracket of the radome.
3. Fasten the ends of the adjustable pipe mounts to the top and bottom brackets of the
radome.
4. Lift the radome and place the screws through the adjustable pipe mounts and position the
radome so that the top mounting holes retain the unit.
5. Screw the bottom two screws and washers into the two standoff fittings at the bottom of
the radome assembly.
6. Tighten all fixing screws.
7. Attach, connect and secure antenna RF cable between the antenna and the appropriate
uMAXe Antenna RF connection on the bottom of the unit.
5.4.1.1 Antenna Mounting Clamps for Dual Slant Antennae
The following are some adjustable antenna mounting clamp options for Dual Slant antenna
scenarios.