User's Manual

uMAXe Installation Guide
Page 32 Commercial in Confidence UGD-D00218 Rev A
Caution: These units weigh approximately 12 kg (26.45 lbs.) take care when
lifting.
4. Screw two M8 screws and washers through the Bottom adapter into the two bottom
standoff fittings in the Rear panel.
5. Check and tighten all the fixing screws.
5.2 Wall mount configuration
The following image shows the wall mount assembly.
Figure 14 – Wall mounting uMAXe
To mount the uMAXe in the wall mount configuration, perform the following steps:
1. Attach the Rear panel to the wall at the height required to attach the uMAXe.
2. Fasten the Top and Bottom adapters to the rear side of the uMAXe enclosure.
3. Align and position the Top adapter so the hooks enter the notches in the Rear panel.
Insert the M8 screws and washers (supplied) in the Top adapter and fasten to the Rear
panel.
Caution: These units weigh approximately 12 kg (26.45 lbs.) take care when
lifting.
4. Screw two M8 screws and washers through the Bottom adapter into the two bottom
standoff fittings in the Rear panel.
5. Check and tighten all the fixing screws.