User's Manual

uMAXe Installation Guide
Page 30 Commercial in Confidence UGD-D00218 Rev A
5 Install uMAXe
Install the uMAXe base station by pole mount, wall mount, or single point. The uMAXe can be
deployed as a remote radio head (RRH) connected to a pair of single (usually vertically polarized)
or single independently mounted antennas via standard RF coaxial cables. Antennas are
positioned with up to 10 wavelengths horizontal separation to give optimal Downlink and Uplink
MIMO performance.
Caution: Proper local rigging and hoisting practices should be followed when
installing the uMAXe. The pre-assembled handles are not to be used for
hanging, attaching or hoisting the unit into place.
5.1 Pole mount configuration
The following image shows the pole mount assembly.
Figure 10 – Pole Mounted uMAXe Assembly
To mount the uMAXe in the pole mount configuration (for poles 60 > 120 MM), perform the
following steps:
Figure 11 - pole mounting brackets (shown assembled)
1. Adjust the pole mounting brackets to properly fit on the pole. Loosely tighten the M12
screws and nuts in preparation for attachment of the Rear panel with the M8 screws, as
shown below: