User's Manual

uMAXe Installation Guide
Page 28 Commercial in Confidence UGD-D00218 Rev A
Optional Junction Box
Consisting of
2x pole bands (stainless steel), as required,
supplied.
78 – 102 mm (4”)
Mounting screws – for mounting brackets to
junction box.
EJOT WN1412 – K50 x 12 – 4 supplied.
Wall mounting fasteners
Hole size = 7 mm
Sufficient cable wires ties, as required
(not supplied - customer responsibility)
4.2.3 Verify Components
uMAXe is shown below from the Ethernet termination and RF port end views respectively.
Figure 6 – uMAXe Base Station Unit, Ethernet termination and RF ports
4.2.3.1 Physical Dimensions
uMAXe BS is in an all outdoor enclosure.
Table 17 - uMAXe physical dimensions
Parameter
Value
Comment
Height
416 mm (16.38 inches)
The physical dimensions exclude handles and
connectors.
Width
336 mm (13.3 inches)
Depth
107 mm (4.2 inches)
Weight
Aprox. 12 kg (26.45 lbs.)
RF Ports for antenna connections are N-Type Female connectors located on the bottom of the
uMAXe enclosure. Adjacent to these are SMA connectors used for RF monitoring purposes
during installation / maintenance. For normal operation, these are covered with a weatherproof
cap.
A 16m RG58 cable connects a remote mounted GPS antenna to the uMAXe or 80cm cable for
connection directly on the uMAXe by way of TNC connectors. Alternatively, an 80cm, cable