User's Manual

uMAXe Installation Guide
Page 12 Commercial in Confidence UGD-D00218 Rev A
Maximum Output TX Power
Table 1 - uMAXe FCC Maximum Output TX Power
Frequency Band
Antenna Gain
1.4 GHz
33dBm
pending
pending
2.3 GHz
36.12dBm
54.12dBm
18dBi
3.65 GHz
36.08dBm
38.08dBm
2dBi
Table 2 - uMAXe ETSI Maximum Output TX Power
Frequency Band
ETSI
TX EIRP
Rest of the World
TX EIRP
Antenna Gain
2290-2350 MHz
36dBm
54dBm
36dBm
54dBm
18dBi
3650-3700 MHz
36dBm
38dBm
36dBm
38dBm
2dBi
Caution: Do not set maximum output TX power to higher than local regulations.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
This radio transmitter uMAXe 3600 3.62-3.7GHz has been approved by Industry Canada to
operate with the antenna types listed below with the maximum permissible gain and required
antenna impedance for each antenna type indicated. Antenna types not included in this list,
having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use
with this device.
This device complies with Industry Canada Standard RSS-197. Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference that may cause undesired operation of the device.
Power Consumption
Table 3 - Power Consumption
uMAXe
Watts
3.x
230 Max
2.x
370 Max
1.4
370 Max
Antenna Types
Table 4 1.4 GHz Antenna Types -Technical
Type
Frequency range
Gain
Part number
60° 13.5 dBi Dual X-Polar
pending
pending
pending
90° 12.5 dBi Dual X-Polar
pending
pending
pending
OMNI Directional
pending
pending
pending