User's Manual

AirSynergy 2000 Installation Guide
Page 46 Commercial in Confidence UGD-D01001 Rev B
Figure 44 - PSU cable connector assembly
10. Insert and secure the red wire into position 1 and the black wire into position 2
Figure 45 - PSU wires assembled
11. Assemble the parts of the connector and tighten the gland to provide a waterproof seal.
Figure 46 - assemble and tighten
12. Fasten the 2 parts of the connector together and tighten to make a watertight seal.
Figure 47 - connector assembled and tightened
7.4 Connecting the AC/DC PSU to Power Supply
The power (mains) connection should be connected to a fused or protected mains supply (100 to
240 Volts AC). The Brown wire is the Live, the Blue wire is the Neutral and the Green/Yellow wire
is the ground wire.
Figure 48 - High power (240W) PSU – used for dual AirSynergy installations
Figure 49 - Standard power (150W) PSU – used for standard AirSynergy installation
The PSU module can be screwed into position using the self-tapping screws provided (4 places).