User's Manual

AirSynergy 2000 Installation Guide
Page 57 Commercial in Confidence UGD-D01001 Rev A
Figure 59 - tighten all fixing screws
Note: It is recommended to place some packing material under the units while
tightening the screws to protect the units from scratches.
The recommended mounting method with pole clamps for back to back installations differs from
the regular mounting due to the additional weight of the 2 units.
Figure 60 - back 2 back mounting
Note: To support the additional weight of a back to back system on a single
universal mounting plate it is recommended that a pole clamp kit is used, as
shown above. This provides a stronger mounting option on the standard telecom
tower equipment pole. For larger diameter poles where pole straps are required
due to the larger pole diameter, it is recommended that 4 straps are used. It is
important that pole straps sit flat against the mounting plate as shown below.