User's Manual

AirSynergy 2000 Installation Guide
Page 55 Commercial in Confidence UGD-D01001 Rev A
o IP Address: Should only be set if Management IP Mode is set to Static IP
Address. See below for Management IP Mode parameter.
o Netmask: Should only be set if Management IP Mode is set to Static IP
Address. See below for Management IP Mode parameter.
o Default Gateway: Should only be set if Management IP Mode is set to Static
IP Address. See below for Management IP Mode parameter.
o Management VLAN: Specified as either Untagged or Tagged
o Management VLAN Tag: Should only be set if Management VLAN is set to
Tagged
o Management IP Mode: Specified as Static IP Address or Obtain IP Address
via DHCP
o Ethernet Mode: Specified as Auto-negotiate or Fixed
o Ethernet Rate: Need only be configured if Ethernet Mode is set to Fixed,
specified as 10M or 100M.
o Ethernet Duplex: Need only be configured if Ethernet Mode is set to Fixed,
specified as Full or Half.
 SNMP configuration information. This will allow events from the BS to arrive at the
specified Netspan server. This will include the following information:
o Read Only Community: This should be specified to the same value as in
Netspan Discovery Parameters (found under Server on Netspan’s left hand
panel).
o Read Write Community: This should be specified to the same value as in
Netspan Discovery Parameters (found under "Server" on Netspan’s left hand
panel).
 Community: Normally specified to the same value as for Read Only Community.