User's Manual

AirSynergy 2000 Installation Guide
Page 54 Commercial in Confidence UGD-D01001 Rev A
9 Appendix A
Review Job Sheet
The Job Sheet should include the following information:
 Pole for installation identified
 Position on pole identified
 Pole access restrictions (highway regulations, other services on pole, power pole)
 Method of reaching pole positions (ladders, Elevated work platform)
 AC main fuse block available for PSU
 Configuration programming details known
 Point of connection for Ethernet (if applicable)
 All equipment items available at the installation site
o Main AirSynergy unit
o Mounting bracket and pole clamps
o PSU
o Ethernet cable assembly
o GPS Antenna
o GPS antenna installation kit
o Front sector Antenna (if applicable)
o Front sector Antenna mounting bracket ad fixing kit (if applicable)
o External panel antenna (if applicable)
o RF feeder cable tails (if applicable)
 Required tools
o Large flat screw driver for pole clamps
o Small flat screwdriver for PoE power terminations
o Small cross-head screwdriver for PoE box lid and fixings for PSU
o 20mm wrench or small pipe wrench for RF connections
o 10mm wrench for main unit mounting flange nuts
o Side cutters
o Wire strippers
o Krone punch down tool
o Tilt meter to set antenna down-tilt
o Ring terminals crimp tool
 Required ancilliary equipment
o Lap top PC for initial configuration
o Ethernet cable for temporary connection of the lap top
 Other install materials
o Self-amalgamating tape
o Black PVC tape
o Cable ties
 Labels
 Whether the system is required to be locked to a GPS timing reference.
 A BSID is required for each AirSynergy. This should be in a format xxxxxx:xxxxxx
where x is a decimal digit.
 Network configuration information for the SDR blade. This shall include the
following information for the front panel and the backplane.