User's Manual

AirSynergy 2000 Installation Guide
Page 47 Commercial in Confidence UGD-D01001 Rev A
8. Prepare the ends of the PSU low voltage cable and thread the connector parts over
the cable.
9. Secure the prepared ends of the drop cable into the head part of the connector (female
part).
Figure 42 - PSU cable connector assembly
10. Insert and secure the red wire into position 1 and the black wire into position 2
Figure 43 - PSU wires assembled
11. Assemble the parts of the connector and tighten the gland to provide a waterproof seal.
Figure 44 - assemble and tighten
12. Fasten the 2 parts of the connector together and tighten to make a watertight seal.
Figure 45 - connector assembled and tightened
7.4 Connecting the PSU to Power Supply
The power (mains) connection should be connected to a fused or protected mains supply (100 to
240 Volts AC). The Brown wire is the Live, the Blue wire is the Neutral and the Green/Yellow wire
is the ground wire.
Figure 46 - High power (240W) PSU