User's Manual

AirSynergy 2000 Installation Guide
Page 38 Commercial in Confidence UGD-D01001 Rev A
Figure 21 - GPS antenna cable connected
3. Attach the GPS antenna assembly to the body of the AirSynergy unit using the single M6
screw and lock washer provided in the kit. There is a threaded hole on the top corner of
the AirSynergy unit for this purpose.
The TNC to TNC cable loop can be carefully positioned behind the front mount antenna
(or the sunshield) as shown below.
Note: weather-proofing (as described previously) should have already been
applied.
Figure 22 - Assembling GPS antenna with bracket to AirSynergy
5.4 Securing AirSynergy to the Mounting Plate
Note: If the installation is for a back to back assembly with two (2) AirSynergy
units sharing the same mounting bracket refer to additional steps in Appendix B..
To mount AirSynergy to the universal mounting plate, perform the following:
1. Loosely fit the flange nuts on the studs protruding from the sides of the unit.
Figure 23 - Lift unit to top of mounting plate