User's Manual

AirSynergy 2000 Installation Guide
Page 35 Commercial in Confidence UGD-D01001 Rev A
Figure 15 – press down locking mechanism
4. Align and position each of the 2 pole clamps. Tighten the clamp bands with large flat
screwdriver in place.
Figure 16 – tighten clamp bands
5. Mounting plate is installed and ready for AirSynergy mounting.
Figure 17 – mounting plate installed on large diameter pole
5.2 Front Sector Antenna Assembly
The AirSynergy unit can be used either with a sector antenna mounted directly on the front or with
a remotely attached antenna. The following describes the installation procedure for the front
mounted antenna.