User's Manual

AirSynergy 2000 Installation Guide
Page 27 Commercial in Confidence UGD-D01001 Rev A
Installation Kit /
Part
Consisting of
Note:
AirSynergy unit(s)
Frequency band specific and
available with and without integral
switched beam antenna.
Verify order and requirement to
ensure the correct unit type is
being installed.
Either of the following
1 x Sun Shield (for single unit
installation where a separately
mounted external antenna is
deployed)
Sun shield with included hardware
(6 Flathead screws)
OR (for front mount antenna option)
1 x Sector Antenna mounting plate
with fixing kit
4 M4 nuts
4 M4 flat washers
4 M4 spring washers
4 Cable ties
4 M5 SEM
1 x Sector Antenna (front mount)
Additionally required for non-switched beam antenna versions of
AirSynergy
GPS Antenna
GPS Antenna mounting kit
Bracket
M6 screw
M6 plain washer
M6 spring washer
TNC to TNC cable (25cm)
Additionally required for back to back unit installations
Note: Dual radio units are usually pre-assembled
from the factory.
1 x back to back joining kit
4 joining straps with mounting
studs and flange nuts pre-fitted.
16 M5 countersink screws
1 x Extended sun shield
( If no front mount antenna is to be
fitted to the front face of the back
to back AirSynergy units)