User's Manual
Airstream 4001 F49-MRT User Guide
Page 36 Commercial in Confidence UWB-D00211 Rev B
If the network requires CPE WAN address to be allocated dynamically (by the network), then
choose DHCP option. Else - choose static IP configuration. The “Protocol” parameter controls the
mode:
2. Select Protocol.
If Static IP is chosen, then configure the following parameters:
3. Enter IPv4 address.
4. Select IPv4 Netmask.
5. Enter IPv4 Gateway.
Once finished:
6. Click Clear to discard any changes.
Or
Click Save to save the changes.
7. Click Save & Apply to save changes. To apply immediately a Reset is required.
Examples:
WAN IP addressing using DHCP:
Figure18‐WANDHCP
WAN IP addressing using Static IP:
Figure19‐WANStaticIPConfigurations