User's Manual

Airstream 4001 F49-MRT User Guide 

Page 35 Commercial in Confidence UWB-D00211 Rev B
14 Network
The Network page of the Airstream 4001 F49-MRT management enables you to configure Bridge
mode or Router mode.
To access the Network page:
1. Click Network to navigate to the Networking page.
2. Choose the desired sub-option from the drop-down list.
14.1 Mode (Router/Bridge) Configuration
To access the Mode (Router/Bridge) page:
1. Click on Network to open the drop down list and choose the Mode sub-option.
Figure17‐Networking‐Bridgemode
14.1.1 Router Mode - WAN IP Address
To configure the Router Mode page:
2. Select Router Mode - to enable Router Mode.
If the network requires CPE WAN address to be allocated dynamically (by the network), then
choose DHCP option. Else - choose static IP configuration. The “Protocol” parameter controls the
mode:
3. Select Protocol.
If Static IP is chosen, then configure the following parameters:
4. Enter IPv4 address.
5. Select IPv4 Netmask.
6. Enter IPv4 Gateway.
Once finished:
7. Click Clear to discard any changes.
Or
Click Save to save the changes.
8. Click Save & Apply to save changes. To apply immediately a Reset is required.
14.1.2 Bridge Mode - WAN IP Address
To configure the Bridge Mode page:
1. Select Bridge Mode - to enable Bridge mode.