User's Manual

Airstream 4001 F49-MRT User Guide 

Page 32 Commercial in Confidence UWB-D00211 Rev B
13 WiMAX
The WiMAX page is used to configure WiMAX scanning for a connection with a base station and
enables you to add, delete and edit channels that the device will use during initial scanning.
To access the WiMAX page:
1. Click WiMAX to navigate to the WiMAX page.
2. Click the desired sub-option on the drop down list.
13.1 Scanning Setup
The Scanning Setup page allows users to stop or start WiMAX connection with a BS, as
displayed below:
To access the Scanning Setup page:
1. Click on WiMAX to open the drop down list and choose the Scanner sub-option.
Figure14‐WiMAX‐Scanner‐Channels
13.1.1 Channels
The Channels page lists all the scanning channels that are stored in the channel table along with
channel status associated to the channel currently used to connect the CPE to a BS. Here one
can add, remove, and edit channels in the channel table.
¾ ID - will display the active channel. This channel is used for the current wireless connection.
¾ Frequency - the channel frequency in KHz.
¾ Bandwidth - the channel bandwidth from the available list. Channel bandwidth - values are:
3.5MHz, 5MHz, 7MHz and 10MHz.
13.1.2 Scanning Setup
The Scanning Setup page enables you to add, delete and edit channels, as shown below:
Figure15‐ScanningSetup