User's Manual
Airstream 4001 F49-MRT User Guide
Page 30 Commercial in Confidence UWB-D00211 Rev B
Figure13‐SystemSoftwareDownload
2. Configure the software upgrade parameters.
3. Check Perform SW Download and Run Shadow after Download.
4. Click Submit.
After the download is completed the downloaded SW file will replace the existing file in the
Shadow bank and the unit will reboot from the Shadow version.
5. Click on Click to Set as Main - to set the file as the main active SW version immediately.
When the unit runs for 5 minutes and the WiMAX link remains stable for the past 1 minute running
the new SW version it will be set as the Main version automatically. If not, the unit will reboot from
the Main version (previously used).
The parameters displayed on the Software Download page are described in the table below:
Table11‐SoftwareDownload&Software Banks
Parameter Description
SW Download
Username Enter - Username for access to the FTP server
Password Enter - Password for access to the FTP server
Protocol FTP/TFTP - protocol for file transfer
Server Enter - IP address of the FTP server
File name Enter - Name of the file to be loaded
SW Download Activation
Perform SW Download Check to perform software download
Run Shadow after Download Check to cause CPE to reboot shadow file
Note: Changes will only take affect after clicking on Submit.
SW Bank Selection