User's Manual

Airstream 4001 F49-MRT User Guide 

Page 17 Commercial in Confidence UWB-D00211 Rev B
6 Connecting WiMAX and WiFi Antennas
Note: Antennas are ordered separately. Contact supplier.
Caution: Before connecting the WiMAX or WiFi antennas, ensure that the
MRTe is not connected to the power source.
Caution: It is the responsibility of the person installing the MRTe to ensure
that only those antennas certified with the product are used. The use of any
antenna other than those certified with the product is expressly forbidden.
Caution: The WiMAX and/or WiFi antennas must be installed only by
experienced installation professionals who are familiar with the local safety
codes and are licensed by the appropriate government authorities.
Caution: Before powering on the MRTe, ensure that some type of equipment
such as the WiMAX and/or WiFi antennas is connected to the RF-type jack.
This eliminates the risk of irreversibly damaging the MRTe device.
To connect the WiMAX antennas (cables) to the MRTe:
1. Hold the WiMAX antenna cable, and gently insert the N type RF plug into the RF jack
labeled ANT1 or ANT2, located on the MRTe’s panel.
2. Secure the antenna to the N type RF jack by hand-tightening (turning clockwise) the WiMAX
antenna onto the threads of the N type RF jack.
3. Before powering on the device, ensure that both WiMAX antennas are attached firmly to the
MRTe.
To connect the WiFi antennas (cables) to the MRTe:
1. Hold the WiFi antenna cable, and gently insert the RF plug into the RF jack labeled WiFi,
located on the MRTe’s panel.
2. Secure the antenna to the RF jack by hand-tightening (turning clockwise) the WiFi antenna
onto the threads of the RF jack.
3. Before powering on the device, ensure that both WiFi antennas are attached firmly to the
MRTe.