User's Manual
Table Of Contents
- Purpose
- Targeted Audience
- Referenced Documentation
- Conventions
- Human Exposure to Radio Frequencies
- Radio Interference
- Avoiding Radio Interference
- Modifications
- General
- Manufacturer's Disclaimer Statement
- European Community, Switzerland, Norway, Iceland, and Liecht
- Declaration of Conformity with Regard to the R&TTE Directive
- MicroMAX-SOC Frequency Ranges
- Main Features
- Customer Benefits
- Architecture
- Power
- Models
- Package Contents
- Required Tools
- Radio Site Planning
- MicroMAX-SOC BSR
- SDA-4S Type II
- Mounting the MicroMAX-SOC
- Pole-Mounting the BSR
- Wall-Mounting the BSR (Optional)
- Installing the SDA-4S Type II
- Connecting the BSR to the SDA-4S
- SDA-4S Type II
- Connecting the SDA-4S Type II
- Connecting SDA-4S to Ethernet Network
- Connecting Lightning and Surge Protector
- Connecting Third Party External Antenna
- 1. Disclaimer
- 1.1 Safety Warnings
- 1.2 Important Warning Symbols
- 1.3 Important Service Information
- 1.4 UL Information
- 1.5 CE Notice
- 1.6 European Community, Switzerland, Norway, Iceland, and L
- 1.7 CAUTION
- 1.8 Lightning Protection
Cabling the BSR
31
mounting holes). The unit may be mounted/grounded on a nearby plate or bulkhead panel
that is bonded to an earth-ground system.
6. Attach the protector's lid by using the four M4 x 20-mm screws. Ensure that the neoprene
gasket on the lid is not loose or out of the groove.
7. Secure the CAT 5e cable to the grommet by fastening the gland nut.
The figure below illustrates the connectivity of the lightning and surge protector.