User's Manual
Table Of Contents
- Purpose
- Targeted Audience
- Referenced Documentation
- Conventions
- Human Exposure to Radio Frequencies
- Radio Interference
- Avoiding Radio Interference
- Modifications
- General
- Manufacturer's Disclaimer Statement
- European Community, Switzerland, Norway, Iceland, and Liecht
- Declaration of Conformity with Regard to the R&TTE Directive
- MicroMAX-SOC Frequency Ranges
- Main Features
- Customer Benefits
- Architecture
- Power
- Models
- Package Contents
- Required Tools
- Radio Site Planning
- MicroMAX-SOC BSR
- SDA-4S Type II
- Mounting the MicroMAX-SOC
- Pole-Mounting the BSR
- Wall-Mounting the BSR (Optional)
- Installing the SDA-4S Type II
- Connecting the BSR to the SDA-4S
- SDA-4S Type II
- Connecting the SDA-4S Type II
- Connecting SDA-4S to Ethernet Network
- Connecting Lightning and Surge Protector
- Connecting Third Party External Antenna
- 1. Disclaimer
- 1.1 Safety Warnings
- 1.2 Important Warning Symbols
- 1.3 Important Service Information
- 1.4 UL Information
- 1.5 CE Notice
- 1.6 European Community, Switzerland, Norway, Iceland, and L
- 1.7 CAUTION
- 1.8 Lightning Protection
Cabling the BSR
27
wires are paired and twisted according to pin functions listed in the table above (e.g. Rx+
with Rx-).
Note: The maximum CAT 5 cable length for ODU/IDU connectivity is 100 meters.
To connect the BSR to the SDA-4S:
1. Connect the 15-pin D-type male connector, at one end of the CAT 5e cable, to the BSR's
15-pin D-type port labeled DATA&PWR&SYNC.
2. Connect the 15-pin D-type male connector, at the other end of the CAT 5e cable, to the
SDA-4S's 15-pin D-type port.
SDA-4S Type II
Using the SDA-4S Type II
The SDA-4S Type II provides one to four RJ-45 (100BaseT) ports for interfacing with the
subscriber's LAN network.
The ports of the SDA-4S model support Auto Negotiation, allowing automatic configuration for
the highest possible speed link (10BaseT or 100BaseT), and Full Duplex or Half Duplex mode.
In other words, the speed of the connected device (e.g. PC) determines the speed at which
packets are transmitted through the specific port. For example, if the device to which the port
is connected is running at 100 Mbps, the port connection will transmit packets at 100 Mbps.
Conversely, if the device to which the port is connected is running at 10 Mbps, the port
connection will transmit packets at 10 Mbps
In addition, the SDA-4S ports support MDI/MDI-X automatic crossover, allowing connection to
straight-through or crossover CAT 5e cables. Therefore, these ports can be connected to either
a hub (i.e. using crossover cables) or a PC (i.e. using straight-through cables).
The cable setup for SDA-4S LAN connectivity is as follows:
Cable: Straight-through (e.g. when connecting to PC) or crossover (i.e. when connecting to
a hub) CAT 5e Ethernet cable
Connectors: 8-pin RJ-45 at both ends
Connector pinouts:
o
Straight-through cable (e.g. connecting to a PC)