User's Manual
Table Of Contents
- Purpose
- Targeted Audience
- Referenced Documentation
- Conventions
- Human Exposure to Radio Frequencies
- Radio Interference
- Avoiding Radio Interference
- Modifications
- General
- Manufacturer's Disclaimer Statement
- European Community, Switzerland, Norway, Iceland, and Liecht
- Declaration of Conformity with Regard to the R&TTE Directive
- MicroMAX-SOC Frequency Ranges
- Main Features
- Customer Benefits
- Architecture
- Power
- Models
- Package Contents
- Required Tools
- Radio Site Planning
- MicroMAX-SOC BSR
- SDA-4S Type II
- Mounting the MicroMAX-SOC
- Pole-Mounting the BSR
- Wall-Mounting the BSR (Optional)
- Installing the SDA-4S Type II
- Connecting the BSR to the SDA-4S
- SDA-4S Type II
- Connecting the SDA-4S Type II
- Connecting SDA-4S to Ethernet Network
- Connecting Lightning and Surge Protector
- Connecting Third Party External Antenna
- 1. Disclaimer
- 1.1 Safety Warnings
- 1.2 Important Warning Symbols
- 1.3 Important Service Information
- 1.4 UL Information
- 1.5 CE Notice
- 1.6 European Community, Switzerland, Norway, Iceland, and L
- 1.7 CAUTION
- 1.8 Lightning Protection
605-0000-742_MicroMAX-SOC_Installation_Rev_D
24
6. Adjust the horizontal positioning of the MicroMAX-SOC (see "Web-Based Management" for
MicroMAX-SOC antenna alignment using RSS measurements), and then tighten the two
M10-hex head screws with the M10 hex nuts.
Note: A third-party thread-locking compound must be applied to the M10-hex head screws
to prevent the bolts from working loose.
Note: For wall mounting, rotation is restricted in the horizontal plane only.
Installing the SDA-4S Type II
The SDA-4S Type II is mounted vertically on a wall.
Wall Mounting
Wall mounting is made possible by the existence of two mounting hooks molded into the SDA-
4S's bottom panel, as displayed in the figure below.