User's Manual
Table Of Contents
- Purpose
- Targeted Audience
- Referenced Documentation
- Conventions
- Human Exposure to Radio Frequencies
- Radio Interference
- Avoiding Radio Interference
- Modifications
- General
- Manufacturer's Disclaimer Statement
- European Community, Switzerland, Norway, Iceland, and Liecht
- Declaration of Conformity with Regard to the R&TTE Directive
- MicroMAX-SOC Frequency Ranges
- Main Features
- Customer Benefits
- Architecture
- Power
- Models
- Package Contents
- Required Tools
- Radio Site Planning
- MicroMAX-SOC BSR
- SDA-4S Type II
- Mounting the MicroMAX-SOC
- Pole-Mounting the BSR
- Wall-Mounting the BSR (Optional)
- Installing the SDA-4S Type II
- Connecting the BSR to the SDA-4S
- SDA-4S Type II
- Connecting the SDA-4S Type II
- Connecting SDA-4S to Ethernet Network
- Connecting Lightning and Surge Protector
- Connecting Third Party External Antenna
- 1. Disclaimer
- 1.1 Safety Warnings
- 1.2 Important Warning Symbols
- 1.3 Important Service Information
- 1.4 UL Information
- 1.5 CE Notice
- 1.6 European Community, Switzerland, Norway, Iceland, and L
- 1.7 CAUTION
- 1.8 Lightning Protection
605-0000-742_MicroMAX-SOC_Installation_Rev_D
22
2. Drill holes for each hole that you marked in the step above.
3. Insert wall anchors (not supplied) into each of the drilled holes.
4. Align the mounting bracket's four holes with the wall anchors, and then insert a screw (not
supplied) through the mounting bracket holes into each wall anchor, and then tighten.
Note: Airspan does not provide screws for attaching the mounting bracket to the wall. The
screw size depends on the structure of the building to which the bracket is to be attached.
When selecting screw sizes, consideration must be given to the weight of the MicroMAX-SOC
and load that may be induced in windy conditions.