User's Manual
Table Of Contents
- Purpose
- Targeted Audience
- Referenced Documentation
- Conventions
- Human Exposure to Radio Frequencies
- Radio Interference
- Avoiding Radio Interference
- Modifications
- General
- Manufacturer's Disclaimer Statement
- European Community, Switzerland, Norway, Iceland, and Liecht
- Declaration of Conformity with Regard to the R&TTE Directive
- MicroMAX-SOC Frequency Ranges
- Main Features
- Customer Benefits
- Architecture
- Power
- Models
- Package Contents
- Required Tools
- Radio Site Planning
- MicroMAX-SOC BSR
- SDA-4S Type II
- Mounting the MicroMAX-SOC
- Pole-Mounting the BSR
- Wall-Mounting the BSR (Optional)
- Installing the SDA-4S Type II
- Connecting the BSR to the SDA-4S
- SDA-4S Type II
- Connecting the SDA-4S Type II
- Connecting SDA-4S to Ethernet Network
- Connecting Lightning and Surge Protector
- Connecting Third Party External Antenna
- 1. Disclaimer
- 1.1 Safety Warnings
- 1.2 Important Warning Symbols
- 1.3 Important Service Information
- 1.4 UL Information
- 1.5 CE Notice
- 1.6 European Community, Switzerland, Norway, Iceland, and L
- 1.7 CAUTION
- 1.8 Lightning Protection
16
MOUNTING THE BASE STATION RADIO (BSR)
Mounting the MicroMAX-SOC
The MicroMAX-SOC BSR can be pole-mounted or wall-mounted (optional). Pole mounting allows the
BSR to be easily adjusted in the horizontal (azimuth) and vertical (elevation) planes for antenna
alignment.
For either mounting method, the MicroMAX-SOC provides mounting holes (displayed in the figure
below), molded into its back panel for attaching the mounting brackets.
Note: The BSR fully complies with IP Code - IPX6 for product enclosure protection.
Warning: The BSR device is an outdoor radio unit, and therefore, must only be
mounted outside.
Warning: Mount the MicroMAX-SOC in an orientation such that its ports (located on
the bottom panel) faces downwards. This prevents rain water from settling on the ports, and
thereby, avoiding damage to the unit such as corrosion and electrical short-circuiting.
Note: The standard BSR kit, provides pole-mounting brackets. If you want to wall-mount
the MicroMAX-SOC, contact your Airspan distributor for pricing and ordering of wall-mounting
brackets.
Pole-Mounting the BSR
Pole mounting allows the MicroMAX-SOC to be easily adjusted in the horizontal (azimuth) and
vertical (elevation) planes for antenna alignment. The BSR is mounted using the mounting holes
located on the BSR's back panel and the supplied pole-mounting brackets. The pole-mounting
bracket is designed to support the BSR on a round pole of 45 mm in diameter.
The figure below summarizes of the MicroMAX-SOC's pole-mounting procedure.